By Patty Heath
This month’s BOM is a great introduction to diamonds with a simple, modern block.
CUTTING INSTRUCTIONS
Fabric A – Teal
Fabric B – Geometric Print
Fabric C – Coral
Fabric D – Gold
BLOCK INSTRUCTIONS
Step 1 – Cutting Instructions
Cut diamonds from Fabric A. Align the 60 degree line on your ruler with the bottom of the strip of fabric. Make a cut from the bottom corner and discard the triangle. reposition the ruler to the right 5.875” keeping the 60 degree line on the ruler even with bottom of the fabric strip. Make a cut on the left edge of the ruler to complete one diamond. Move the ruler once more to the right 5.875” and make another cut to complete a second diamond. Repeat from the beginning with Fabric B.
Step 2
Sew the diamond shapes together as shown in the photo. Press seams open being careful not to stretch the bias edges.
Step 3
Cut Fabric C and D rectangles diagonally as shown to create half rectangle triangles. Important note: If using a fabric with a discernible front and back, you must cut 2 of the 6×10.25″ pieces and cut them diagonally in opposite directions.
Step 4
Mark the center of the long side of each half rectangle triangle and pin to the corresponding seam of the diamond block as shown. Sew and press seams open. Trim block to 10.50” X 18.50”.
Step 5
Sew remaining Fabrics C and D to the corresponding sides of the block. These pieces have been cut slightly larger to allow for trimming the finished block to 18.50” square.
On Instagram make sure to use #bouldermqgbom20 and tag us @bouldermqg